How to setup DVR network?

How to setup DVR network?

Postby CCTV Professional » Thu May 12, 2011 7:12 pm

Simple steps for DVR Network Setup:

In Computer
- Start->Run->cmd->ipconfig /all
- Put (IP address, Subnet mask, gateway, DNS) information in the DVR network setup. (Note: The 4th segment of IP address must be different with your computer's)

In IE web browser
- Go to Tools->Internet Option->Security->Custom Level->enable all ActiveX (about 8 of them)

In Router,
- Do Port Forwarding.
- Test if the ports are open
(If the ports are closed, you need to contact your Internet Provider to unblock them or change the modem.)
CCTV Professional
 
Posts: 61
Joined: Fri Jul 10, 2009 8:18 am

Re: How to setup DVR network?

Postby CCTV Professional » Wed Feb 15, 2012 6:25 pm

Detail steps for DVR Network Setup:

1. Connect DVR with Router. (Internet Lights should be ON at the back of the DVR)

2. In Computer
- Start (left bottom of the Windows)->Run->cmd->ipconfig /all

3. In DVR
- Insert (IP address, Subnet mask, gateway, DNS) information in the DVR network page. (Note: The 4th segment of IP address must be different with your computer's,e.g. 192.168.1.xxx. The xxx part shoud be different)

4. In Computer
- Start (left bottom of the Windows)->Run->cmd->ping DVR IP address (Should return bytes, time and TTL#)

5. In IE web browser
- Go to Tools->Internet Option->Security->Custom Level->Enable all ActiveX (about 8 of them)
- Type http://192.168.1.xxx at the address bar, view the video

6. In Router
- Do Port Forwarding.
- Test if the ports are open using below link:
http://cctvdirectbuy.com/download/tech/port_check.htm
(If the ports are closed, you need to contact your Internet Provider to unblock them or change the modem.)
CCTV Professional
 
Posts: 61
Joined: Fri Jul 10, 2009 8:18 am


Return to Security DVR Network FAQ



cron